Side electric step E1 for VW Crafter and MAN TGE

Side electric step E1 for VW Crafter and MAN TGE

SKU: 110E1-VC17RW-R
Category: elektrische Seitentrittstufe

- Electric step in three step
widths - Slip resistance R13 according to DIN 75078-1
- Duplex
coating - For rear-wheel and all-wheel drive

Stufengröße:

from

1.265,00 €

incl. 19% VAT , plus

Available immediately
Delivery time: 2 - 3 Workdays (DE - int. shipments may differ)

Description
PDF (1)

Side electric step for VW Crafter and MAN TGE

For the MAN TGE and VW Crafter from model year 2017 onwards for rear-wheel and all-wheel drive with the following wheelbases

:- Wheelbase L3: 3,640 mm with a cargo area length of: 3,450 mm and a total vehicle length of: 5
,986 mm - Wheelbase L4: 4,490 mm with a cargo area length of: 4,300 mm and a total vehicle length of: 6,836 mm
- Wheelbase L5: 4,490 mm with a cargo area length of: 4,855 mm and a total vehicle length of: 7,391 mm

The step can be ordered for either the sliding door on the driver's side or the passenger side.

The electric side step features a high-quality aluminum surface. When extended
, the step surface measures 600 x 300 mm, 1,000 x 300 mm, and 1,200 x 300 mm.
The electric step can bear loads of up to 250 kg. This means that several people can get in and out at the same time.

The E1 step features a closed cassette system for a long service life and protection against environmental influences.
The slip resistance R13 is higher than required by DIN 75078-1 (KMP).
A POWER MODE for a short-term increase in power supply helps with difficulty due to protection or other adversities.
The yellow reflective strip is particularly easy to see when getting in and out.

Dimensions/weight:	600 x 300 mm/20 kg
Dimensions/weight:	1,000 x 300 mm/33 kg
Load capacity:	250 kg
Vehicle:	MAN TGE, VW Crafter
Wheelbase:	L3+L4+L5
Drive type:	Rear-wheel and all-wheel drive
Year of manufacture:	From 2017
Certification:	CE marking/ECE R10 certificate
Slip resistance:	R13 according to DIN 51130
Displacement space:	V04 according to DIN 51130
Installation time:	Approx. 4 hours

The features of the E1 step at a glance

- CE
marking - ECE R10 certificate
- Duplex-coated housing
- Slip resistance R13 according to DIN
51130 - Displacement space V04
according to DIN 51130 - High abrasion resistance (aluminum oxide grain)
- UV-resistant and
temperature-stable- Resistant to chemicals (oil, brake fluid, etc.)
- Classification C according to DIN
51097 - Running board covering tested for 1,000,000 steps
- Standby mode I- Simple emergency release
- Automatic
collision detection - Automatic load detection (15kg)
- Automatic or manual mode

The following items are included in the scope of delivery:

- Integrated collision detection
- Load detection/automatic or manual mode
- Vehicle-specific installation kit
- Warning light
- Cable
set - Door contact switch