Volkswagen Transporter floor

Are you looking for a floor panel for your VW Transporter?
Then you will find your perfectly fitting CNC-milled Transporter floor made of birch plywood for VW panel vans here
. The floor panels are available for the VW Crafter, VW T5, VW T6, VW T6.1, and VW Caddy, as well as for the VW Crafter with double cab.
In combination with a cargo area lining and wheel arch lining, this provides optimum protection for the cargo area.

Features of the VW floor panels for panel vans

We offer floor panels for Volkswagen commercial vehicles in a variety of colors, finishes, and surfaces.
They are available in gray, brown, black with a granite finish, or as a slip-resistant version with a sturdy rubber-plastic coating.
The transporter floor itself is made from a phenolic resin-coated birch plywood panel, in thicknesses of 9 or 12 mm, cut to size using a CNC milling machine.

The 9 mm thick screen-printed panel is suitable for normal transport, such as the transport of light pallets or general cargo.
The 12 mm thick transporter floor is designed for heavy-duty use, such as the transport of heavy pallets, the installation of vehicle equipment, or the insertion of airline rails.
The floor panels are supplied in one piece, as in the VW Caddy with a short wheelbase, or in several pieces, as in the VW Crafter and VW T6. This has proven to be an advantage, as it makes installation much easier and significantly reduces the risk of damage to the vehicle during assembly.

Depending on the vehicle, aluminum strips are milled into the surface of the floor panel at the sliding doors or rear doors.
The original lashing eyes in the floor area are replaced by lashing recesses. These are also milled into the surface without any protruding edges.
They are attached by screwing the lashing eye into the lashing recess.
In vehicles without lashing eyes in the floor, the floor panel is closed and must be glued, riveted, or screwed in place.

Transporter floor with airline rails for VW Transporters

Our 12 mm thick floor panels can be extended with pre-milled and glued airline rails.
Normally, airline rails are embedded parallel to the crossbars in the roof so that, in combination with locking bars, vertical load securing can be achieved.
This is often required when transporting windows, screen printing plates, or wooden panels.
On special request, we can mill the airline rails into almost any position.

Vehicle equipment and transporter floors

When installing vehicle equipment in Volkswagen commercial vehicles, the stronger 12 mm floor is advantageous, as the load is concentrated in specific areas.
The tensile strength of embedded threaded sleeves for fastening the modules is significantly higher with 12 mm thick floor panels.

Our transporter floors are made of wear-resistant and durable material. The underside of the floor panel is smooth and the top side is embossed with a screen print.
A special feature is the anti-slip transporter floor, which is coated with a slip-resistant surface on the top side.
Choose the vehicle floor that suits you best from a wide range of different coatings, colors, and thicknesses.